If your looking to make a really nice, and fairly simple Induction Heater, then look no further, See the link below for the schematic.
This device will heat a screwdriver tip to glowing red in approximately 30 seconds. The coil design can also be modified to a pancake style just like what is used in modern electric induction cooktops. Follow ALL instructions in the video, and link below. Depending on how your unit is made, results may vary.
Don't want to make one? Then buy one cheap at the link below:
**Try these money saving coupon codes: affiliate6 or aff7off or f8aaf1 or 781622 or 5719ed or elec** or ask if other codes are available!
Resonant Frequency Calculator is here:
Use this tool here to calculate your working coil inductance value:
12ga copper wire is 2.03mm.
**Watch PART 2 which shows a spiral coil and current measurements!**
**For GREAT deals(Usually cheaper than EBAY) on electronics, drones, automotive tools, household items, phone accessories, locksmith tools, & much more, please visit the link below and SAVE IT AS A BOOKMARK on your computer or smartphone to Banggood for future purchases. (Your purchase supports my channel!)
All Items: bit.ly/2cgYr14
Flash Deals: bit.ly/2cb6CZB
Use one of the coupon codes listed above!
**If you like this video, be sure to check out my other 450+ videos! Also Subscribe, and tell your friends about this channel**
**Help me make more videos. All donations(big or small) are greatly appreciated: